Glacier White 200 Cup

[burrellbloke]

The car drives better without the spacers on the rear, but the rear end looks awful without spacers as the wheels get lost in the arches.

I think in the future we will start every track day without the rear spacers unless we are having any stability or handling issues.

 

[Beany]

sounds like a good day, it’s not too far from me is Blyton, if fortune allowed it I should’ve popped over. The joys of kids!

 

[burrellbloke]

sounds like a good day, it’s not too far from me is Blyton, if fortune allowed it I should’ve popped over. The joys of kids!

Yes, the joy they bring and the responsibilities you have to deal with. It's okay they grow up at some point and you get your life back.

 

[burrellbloke]

A few of Robert Baxter's finest photographs from Blyton Park on Saturday.

 

[burrellbloke]

I have had a look at the GoPro footage that I captured at Blyton and the front camera footage is all over exposed. This is the best I could do with a bit of post production with @EthanMenace vs @Tarticmonkey

 

[Tarticmonkey]

Love the video; thank you for that!

 

[LiamP]

The car drives better without the spacers on the rear, but the rear end looks awful without spacers as the wheels get lost in the arches.

I think in the future we will start every track day without the rear spacers unless we are having any stability or handling issues.

As a middle ground you could put a set of 10mm PMS stub axle spacers on, I had a set on mine.

 

[Beany]

I have had a look at the GoPro footage that I captured at Blyton and the front camera footage is all over exposed. This is the best I could do with a bit of post production with @EthanMenace vs @Tarticmonkey

Nice little video… shame the exposure ruins it in certain areas! The joys of GoPros and fiddly settings

 

[burrellbloke]

I have discovered that the afternoon footage from Blyton Park did not suffer the same fate as the over exposed morning footage.

Here is @EthanMenace's fastest lap.

Here is my fastest lap.

 

[burrellbloke]

I spent a few hours today cleaning the Clio. It had not been cleaned after its recent trips to Mallory Park and Blyton Park and was covered in tyre debris. Also, @EthanMenace had hit a some of the "track furniture" at Blyton Park and that left some marks on the passenger side of the front bumper.

This is what it looked like before I cleaned the car.



After a good clean and liberal use of some Meguairs Ultimate Compound the marks disappeared.



We have looked at the set of Direzzas that we used from the summer last year up until Mallory Park and they seemed to have worn quicker on the inside edge leaving more tread of the outside edge of the tyres. We will get the geo set up with some more aggressive camber at the front and move from 3.5 to about 4 to 4 and a bit degrees of negative camber. The rear axle only has about 1.5 degrees of negative camber so we might shim that up to 2.5 degrees of negative camber. Hopefully a more aggressive set up at the front will even out the tyre wear as we think that we have tyre pressures about right.

The gearbox is still a bit "crunchy". I will book an alignment at AW Motorworks and see if Alex has any good suggestions to sort out our clutch drag issue. We have bled the clutch as much as we can and now wonder if there are any other ways to improve the situation that don't involve taking the gearbox out again. An odd thing that I have noticed since the slave cylinder was replaced is that the ignition is turned on the car displays a "Select neutral" message on the dashboard before the start button is pressed even when the car is in neutral. We did not get this message before.

 

[RSRowe]

Surely more camber is going to result in more of the same wear you're seeing?