needforspeed
Gold Member
PITAs GW 200 FF Cup
- Thread starter PITA
- Start date
PITA
Paid Member
I’ve yet re-gap them, they’re still at 0.6mm. I’ll see how she drives and attempt to open the gaps up although that is quite difficult without the right tools
PITA
Paid Member
Good and bad news. The misfire is gone, she revs all the way out to redline with these coils. I think maybe they’re masking a problem with my battery, alternator or both. The voltage trace in the ECU is erratic whereby the volts ramp up to 14.5 then drop to 13. This all takes place over 30 seconds or so.
Bad news is the charger threw the aux belt off, battery light came on pretty quickly afterwards (again points to a crap battery). It’s bent some fins on the supercharger oil cooler but fortunately not wrapped around anything else. Hopefully the engine is ok.
Bad news is the charger threw the aux belt off, battery light came on pretty quickly afterwards (again points to a crap battery). It’s bent some fins on the supercharger oil cooler but fortunately not wrapped around anything else. Hopefully the engine is ok.
needforspeed
Gold Member
Been there what bracket are you using? can you squeeze another small pulley in there for more wrap?
PITA
Paid Member
It’s Supremes bracket, I think there’s pre tapped holes for another pulley but I have no idea where I’d source one or which belt to get.
PITA
Paid Member
I managed to fit another pulley for more wrap with a longer belt. It’s mounted on the rear mounting bolt as the other hole won’t
After fitting these I took her out to try it and she’s faultless and relentless. 100+ soon comes around and there’s no more misfire. The noise from the PMS manifold and Akrapovic is lovely, it gives a nice little burble on over run. I’m back in love.
After fitting these I took her out to try it and she’s faultless and relentless. 100+ soon comes around and there’s no more misfire. The noise from the PMS manifold and Akrapovic is lovely, it gives a nice little burble on over run. I’m back in love.
PITA
Paid Member
She’s going to Fulcrum next week for to have this full bolt in cage fitted. I’ve stripped the car of all its plastics and luxuries (should have just bought a cup lol). Roll on Croft
suj
Paid Member
PITA
Paid Member
There’s no going back now! She’s with Tom at Fulcrum for the cage and I’ll hopefully be picking her up on Monday.
I’ll then look to thin out the loom and remove all unnecessary brackets ready for a lick of paint. I’ve got some Trackday Doorcards on order and hopefully they arrive before Croft. I’m going to relocate the window switch and mirror knob to the centre console as opposed to cutting the door cards.
av4625
Paid Member
PITA
Paid Member
PITA
Paid Member
PITA
Paid Member
PITA
Paid Member
suj
Paid Member
Going to look great parked up in the pits, with the laptop out reading logs.....
Haha kidding looks great!
Haha kidding looks great!
PITA
Paid Member
Sounds better than being in the barrier/on the back of recovery. I’ll take it
R20BTG
Paid Member
Similar Thread Suggestions
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
|
200 - Chirp/whistle and occasional high idle | Clio 200 Area | 7 | |
|
200: Clio 3rs 200 difficulty changing gear at high revs? | Clio General Chat | 2 | |
|
ly 200 at the motorist 05.10.24 | Spotted | 0 | |
|
RS200 engine lights coming on, advice needed | Clio 200 Area | 4 | |
|
|
New RS200 owner | New Members | 2 |