Mini project - Cup Racer Alloys

Out of interest what was the cost on the four? Have you seen any of the work done by CAS powdercoating who are also in leeds? Not sure if it's costs are still the same, but last I heard they were offering p/c for £1/inch.

I'll be putting 888s on this set, with roadies on the other to cover the typically british summertime monsoon conditions that can no doubt be expected next year :smile:
 
What does the wheel specialist do, do they powder coat too or spray?

Looking great by the way Grumps, hope to see them in Sheffield soon! :thumbup:
 
Yeh i thought so when we were last at Cadwell he was rolling on OZ .

Shame as these looked sweet

Super heavy though, went for function over form and wouldnt go back to be honest. The aleggeritas make quite a difference.
 
Not sure where to put these really but seeing as they were asked for in here I found some snaps I took when test fitting (note the snow :tongueout: )

IMG_6777.jpg


IMG_6741.jpg


If I get the money at some point I'd like to get some coilovers, it's not so bad at the front imo but the 200/197s are very high at the rear.
 
Last edited:

Similar Thread Suggestions