Heating issues: Fan not turning on

Kalamat88

Platinum Member
Hi all,

The Clio is having problems overheating due to the secondary fan not coming on.


You wouldn’t realize it in short 10-15 minute trips- it rides fine on the highway, zero issues with the constant flow of air coming in, but slowly but surely in stop and go traffic, the temperature warning goes off.

I’m starting to think I unplugged something accidentally or maybe a fuse? I checked a few fuses but that could still be a problem, too.

Any ideas on where to check first?

IMG_2033.jpeg

These two look plugged in and good to go- anywhere else I’m missing that I should check connector-wise?

As always, thank you all!
 
Thank you, Veiron, will take a look.

Are these the only two “plugs” to the fan?

Any other ideas guys, feel free…
 
I don’t have any needle nose pliers so I wound up doing this.

The fan didn’t come on at all despite the engine fully warmed up and the AC on. I’m this close to taking it to a shop as I don’t do well with electrical stuff.

Here’s also the connector to the fan- it was a bit damp so I spray it with some compressed air and let it sit.
 

Attachments

  • IMG_2046.jpeg
    4.8 MB · Views: 13
  • IMG_2045.jpeg
    4 MB · Views: 11
  • IMG_2044.jpeg
    IMG_2044.jpeg
    1.4 MB · Views: 6
I have just finished working on a Clio 200 Cup and no radiator cooling fans were running. The car flashed up "STOP" along with the gear change/ low fuel beep as it ran in the garage. I could see the temperature gauge was high and shut off the engine within seconds. Luckily, I was beside the car when it happened and damage was avoided. The car has been standing outside for a couple or more years, unused when acquired, and I was repairing and getting it ready for MOT.

I've seen your photos, but the point was to connect the two points together, which is the same as the car turning on the high-speed fan on. There might be a few sparks as contact is made. So look below, and we will go through this step by step. I checked if the fan worked first, then moved to the UPC and checked the low and high speed relays inside. I got the low-speed fan working, but in the end, the UPC had to be changed, which I have done tonight, as the UPC's internal relays or transistors could not trigger the high speed relay to come on. If you don't have long nose pliers us metal Scissors.
1795296403118.png

1. Make sure the fan turns by hand (from underneath reach up with everything turned off and spin the fan) If you have electrical contact cleaner (I'm not a fan of WD40 on electrics) spray it through the vent holes to clean the motor contacts as you spin it.
1795297840964.png
2. Make the connection between the two points and see if the fan can turn by itself with direct power you need to make sure everything is plugged in on the fan assembly.

Now either the fan will work (the car does not need turned on) or there is no positive power for the fan (possible fuse problem)
1795299170779.png
1795299365313.png
1795299497864.png
1795302048950.png
1795303845512.png
 
Last edited:
  • Like
Reactions: Sean197