help with FK automotive 20mm spacers

[Dmonk197]

just got these and didn't realize i need longer bolts. anyone have these and can tell me what bolts i need to get?

 

[Tree200]

Think slandered are 27mm so some 47/50mm should do

 

[M88KE C]

Yes but there is a certain thread pattern and I can't think of it! A search of the forum will find it Dmonk

 

[Dmonk197]

I for one always use the search function first.
could not find anything but will look again.

 

[Tree200]

Oh err 60 degree cone and m14*1.5

 

[M88KE C]

That sounds about right!

 

[Dmonk197]

thank you

 

[Dmonk197]

Oh err 60 degree cone and m14*1.5

what length? is it 27/28

 

[Tree200]

27 mate with a 19mm head

 

[Dmonk197]

27 mate with a 19mm head

thank you

 

[Dmonk197]

so from my understating i need :

60 degree cone
m14*1.5
with a 47mm thread
and a 19 mm hex head

all i can find is 17 mm hex head
anyone have a link to one?

and what about locking ones for security?

 

[Tree200]

Wouldn't worry about having 17mm head, an try this http://www.ebay.co.uk/sch/m.html?_o...C0&_nkw=20+x+M14X1.5+50mm+&_sacat=0&_from=R40

 

[Tree200]

You can get extended locking wheel bolts too, I don't run locking bolts after my last ones were chewed up

 

[marshall]

I had those in that link above. We're spot on. Preferred 17mm hex as the socket didn't ruin the I paint on the bolt holes

 

[Dmonk197]

Perfect, thank you guys!

 

[marshall]

Just make sure you get extended ones...20mm longer than the standard ones.

I ordered...http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=280868670649&ssPageName=ADME:L:OC:GB:3160

The only thing i will say is that they pertrude out the back of the hub a little. Which is fine. But the back end of the thread in the hub was caked in **** making the bolt tighten against the back of the hub not the wheel if u get me? Run the bolts into the hub first just to make sure they tighten properly.

 

[AJ68]

Marshall, I have 17mm spacers, would these 50s protrude too much or would you go for 40mm, thanks

 

[Dmonk197]

so i ordered these 50mm ones as advised, and they are the same length as the standard and obviously dont fit, so i need 70mm ones? can someone confirm?

 

[jimfacebinface]

Measure the length of a standard bolt and add 20mm... Wouldn't that suffice?

 

[Tree200]

Have you measured the length if the ones you ordered to make sure they are 50mm?