ex Nimbus r27r #2054

yesterday i went to mech to adjust front and reax toe and camber... :wink:

Front axis
height 33.5cm
toe 0
camber -2,00°

Rear axis
height 33cm
toe +10'
camber -1.9°

for rear axis i used:
-7711160170 Piastra toe 30'
-7711160172 Piastra toe 10'
-7711160174 Piastra camber 30'

for each side
 
Last edited:
This is something I'd have to do in the future...my rear axis is a bit out, within tolerance but still out. Why didn't you have 0 toe at the back Simo?
 
Hi mate!! :smile:

How obtain 0?

i'm +10' with 2x10' and 2x30'..
5' don't exist.. i'd need to remove 10' from only one side but... is not a good choice i think!

So, +10' is better than -10'...
 
Tell me something, why is it when i say **** , it gets censored with little stars...yet your'e allowed to put pictures of your car up and it doesnt get blurred out?

That colour is pure unadulterated porn, will be saving that to the ipad for later on me thinks :smile:
 
is that for the airbox or for the brakes?

you have to show me this on sunday :wink:

For the airbox ollie!b:smile:
I thought to remove the wheel arch for refresh all.. but then i decided to fit only this pipe..
With our winter will no have problem with brake i think..also beceuse ultraleggera is very "open"

Tell me something, why is it when i say **** , it gets censored with little stars...yet your'e allowed to put pictures of your car up and it doesnt get blurred out?

That colour is pure unadulterated porn, will be saving that to the ipad for later on me thinks :smile:

:lol::lol::lol:

Thanks mate!!