Coilover help (setup)

[m.barnes]

ah i see. Not sure where ben got his front to rear height splits, but it might be worth measuring the front from floor to bottom of wishbone and measuring the rear from floor to mounting bolt on the rear axle.

 

[ben_r1]

Measured mine the same as A2ON did. Thats the way they came setup from AmD and im assured its the best stance performance wise.

 

[CraigAPD]

Have you got access to CW scales?
Thats the only real way to get anywhere close with RH, but on a FWD closed-wheel car it can be fun!

 

[A2ON]

Don't think we have a garage anywhere near me to do cw I'm happy with bens measurments just don't understand why its sagged on the front ?

 

[CraigAPD]

If youve JUST adjusted them statically after first fitment, then they will sag as the suspension joints and springs settle.

Best thing is to set it slightly over the mark, take it for a good spin, then re-adjust.

 

[ben_r1]

As said before A2ON the harder the dampers are set the lower the car sits, and iced versa. My height measurements are taken from the STD/soft setting I gave u.

 

[CraigAPD]

Damping rate wont affect RH when static.

 

[A2ON]

@ ben yeh did same height u surgeted at 7&4 which is same as yours .

It's no biggie I'll just re adjust height or should I say get someone too lol

cheers craig and ben

 

[ben_r1]

Damping rate wont affect RH when static.

If he adjusts and then goes for a ride round the block I assure u it will alter though.

 

[CraigAPD]

What poundage springs are you running?
Damping shouldn't have any affect on static RH alone....very odd!