2014 Renault Clio 4 - Intermittent Front Wipers, Stopping Mid-Glass & DTC923897 / DF117 (Front Wiper Motor Memory Error)

Hi everyone,

I’m troubleshooting a recurring front wiper issue on my 2014 Renault Clio 4 (0.9 TCe) and would appreciate some input before replacing parts.

Symptoms:

  • The front wipers work normally at times, then completely stop responding.
  • Sometimes they freeze right in the middle of the windshield instead of returning to the park position.
  • Other times, only the highest speed setting works while intermittent and low speeds do nothing.
  • Whenever this happens, scanning the EMM / UPC (11290) module shows DTC923897 / DF117 (Front wiper motor memory error / component blocked).
  • Clearing the fault code via OBD temporarily restores normal wiper operation until the fault triggers again.
What I Have Checked & Tested So Far:

  1. Wiper Linkage: Disconnected the motor and checked the linkage arms by hand—they move freely with no binding or stiffness.
  2. Wiper Motor Inspection: Opened the plastic gearbox cover on the wiper motor, cleaned the contacts, and slightly bent the spring-loaded park contact fingers upward. This helped temporarily, but the issue returned.
  3. Direct 12V Bench Test: Applying direct 12V to the motor spins it without issues.
  4. Live Data & Actuator Tests (via PyREN):
    • Confirmed the UCH module accurately reads the wiper stalk positions (Off / Low / High).
    • Ran an Actuator Test (AC) directly from the 11290 EMM/UPC module:
      • Low speed command: The motor did not move at all.
      • High speed command: The motor ran, but as soon as the actuator test timed out, the wipers stopped dead in the middle of the glass instead of self-parking.
My Question:Since clearing the DTC restores power and the high-speed actuator test works, I suspect the EMM/UPC output driver is fine, and the wiper motor itself has worn internal low-speed brushes and a failing park-position switch under load. Before I order a new OEM Valeo wiper motor, is there any chance a faulty relay/circuit inside the EMM/UPC could cause these exact actuator test results (no low speed + failing to self-park after high-speed test)?
 
Before buying the Valeo motor I’d want to check what’s actually reaching the motor when the fault is present low speed supply earth voltage drop under load, and the park signal using the correct wiring diagram If the supply and earth are good but it won’t run on low that points towards the motor If the supply is missing I’d investigate the wiring connectors and UPC side before ordering parts.
 
  • Like
Reactions: eraydev
Before buying the Valeo motor I’d want to check what’s actually reaching the motor when the fault is present low speed supply earth voltage drop under load, and the park signal using the correct wiring diagram If the supply and earth are good but it won’t run on low that points towards the motor If the supply is missing I’d investigate the wiring connectors and UPC side before ordering parts.
I will measure and try to measure how many v electricity goes to the engine when the fault is present in the near future, the upc brain is about 300 euros, while the wiper motor is about 250 euros. It has been rainy for 1 week now. When the weather improves, I will check again with full measurements
 
Before buying the Valeo motor I’d want to check what’s actually reaching the motor when the fault is present low speed supply earth voltage drop under load, and the park signal using the correct wiring diagram If the supply and earth are good but it won’t run on low that points towards the motor If the supply is missing I’d investigate the wiring connectors and UPC side before ordering parts.
But I suspect that when the fault occurs, no electricity is sent to the motor by the UPC because the motor doesn't make any noise.