2014 Renault Clio 4 - Intermittent Front Wipers, Stopping Mid-Glass & DTC923897 / DF117 (Front Wiper Motor Memory Error)

Hi everyone,

I’m troubleshooting a recurring front wiper issue on my 2014 Renault Clio 4 (0.9 TCe) and would appreciate some input before replacing parts.

Symptoms:

  • The front wipers work normally at times, then completely stop responding.
  • Sometimes they freeze right in the middle of the windshield instead of returning to the park position.
  • Other times, only the highest speed setting works while intermittent and low speeds do nothing.
  • Whenever this happens, scanning the EMM / UPC (11290) module shows DTC923897 / DF117 (Front wiper motor memory error / component blocked).
  • Clearing the fault code via OBD temporarily restores normal wiper operation until the fault triggers again.
What I Have Checked & Tested So Far:

  1. Wiper Linkage: Disconnected the motor and checked the linkage arms by hand—they move freely with no binding or stiffness.
  2. Wiper Motor Inspection: Opened the plastic gearbox cover on the wiper motor, cleaned the contacts, and slightly bent the spring-loaded park contact fingers upward. This helped temporarily, but the issue returned.
  3. Direct 12V Bench Test: Applying direct 12V to the motor spins it without issues.
  4. Live Data & Actuator Tests (via PyREN):
    • Confirmed the UCH module accurately reads the wiper stalk positions (Off / Low / High).
    • Ran an Actuator Test (AC) directly from the 11290 EMM/UPC module:
      • Low speed command: The motor did not move at all.
      • High speed command: The motor ran, but as soon as the actuator test timed out, the wipers stopped dead in the middle of the glass instead of self-parking.
My Question:Since clearing the DTC restores power and the high-speed actuator test works, I suspect the EMM/UPC output driver is fine, and the wiper motor itself has worn internal low-speed brushes and a failing park-position switch under load. Before I order a new OEM Valeo wiper motor, is there any chance a faulty relay/circuit inside the EMM/UPC could cause these exact actuator test results (no low speed + failing to self-park after high-speed test)?