Recent content by EvoClio

  1. E

    RS200 Internal Engine Light Ticking - Suspected Crankshaft Bearing

    Hi All, The car was recently in the garage for a replacement O2 sensor, I noticed a very light ticking noise develop over the last 1000 miles (LH Side Engine Bay). When I drive the car, the ticking is in sync with the revs and is mostly noticeable around 1500-2000 revs. The garage also...
  2. E

    RS200 MK3 - Ticking Noise with Revs

    Morning rcwsr, mine is quite distinctive from in the car and recently threw up an EML. 2000 revs seems to be where it's noticeable - is this the same for you? I'll check out my flexi's and manifold welds to see if I can spot anything.
  3. E

    Evo's RB Clio 200 CUP

    Day 5: Collected the Clio, ready to begin enjoying the car and I was presented with a little treat on the dashboard. Not off to a great start!
  4. E

    RS200 MK3 - Ticking Noise with Revs

    Well, today things have escalated. Car started with an EML 'Check Emissions', killed the ignition and started her up again, it bogged and struggled but kicked back in to life. I presume the EML is in correlation to the ticking noise I reported a few days ago. I'm thinking... Manifold *sigh*.
  5. E

    Aftermarket Exhaust - Scorpion

    Only one way to find out, I guess!?
  6. E

    Aftermarket Exhaust - Scorpion

    Thanks for the info! Resonated is probably the way to go - do you have an aftermarket manifold too?
  7. E

    Aftermarket Exhaust - Scorpion

    If you're able to check under the car anytime soon, the non resonated doesn't have a silencer in the centre pipe. If you check Scorpions website and compare the two system, it's easy to spot. Out of curiosity, are you running the decat too? I'm looking to go down the route of resonated...
  8. E

    Evo's RB Clio 200 CUP

    Good call! I need to ascertain if it's most definitely the manifold and if so... what my plan of action is. I'll likely go aftermarket or custom built but can't imagine it being to cheap - I have intentions of a catback exhaust so probably best to do it all together. My sentiments exactly...
  9. E

    Aftermarket Exhaust - Scorpion

    Thanks for the input Beany. I think decat is the way to go as I'm guessed it adds the extra pops and noise. The big question is.. resonated or non-res. What are you running?
  10. E

    Aftermarket Exhaust - Scorpion

    Thanks for the info Johnny. I'll try and contact Dave - thanks again.
  11. E

    Aftermarket Exhaust - Scorpion

    Hi All, No doubt, Exhausts have likely been discussed more times than you you could possibly count; I apologies in advanced. I've got a standard system on mine and looking for the extra noise! Scorpion appear to be pretty well rated and the way to go, according to their official website they...
  12. E

    Evo's RB Clio 200 CUP

    First and foremost, welcome fellow petrol heads, car enthusiasts and lurkers to my Project/Progress Thread. I am the proud owner of a Clio RS200 CUP MK3 (2009) in Racing Blue; purchased in February 2019 with approximately 79,000 miles. As of writing this post, I've owned the car for 4 days...
  13. E

    RS200 MK3 - Ticking Noise with Revs

    Sounds exactly as you've described and irritating indeed! I'll check over the exhaust system and see if I can at least pin point if it's definitely the point of failure. I'll go from there, I planned to get a new exhaust in the near future anyway.