Trackspec Clio 197
- Thread starter trackspec197
- Start date
Pav
Moderator
best stuff is coming your way..all the wiring etc..hope all goes well..
Thanks mate.
Thankfully should be plug and play as it's Sean's old loom out of his conversion.
Heat shielding done. Doesn't look like much for almost £100! Went with Zircotec ceramic heat shield material.
Can anyone advice the best way for me to run the two vacuum hoses?
Can anyone advice the best way for me to run the two vacuum hoses?
Unfortunately I dislocated my shoulder this morning which will no doubts slow down progress. Gutted! but we'll get there!
Pav
Moderator
think you are not being completely honest here with us..
did you try a new position with your lady and it didnt go the way you had planned??
did you try a new position with your lady and it didnt go the way you had planned??
haha I only wish! We were playing cops n robbers!think you are not being completely honest here with us..
did you try a new position with your lady and it didnt go the way you had planned??
Pav
Moderator
its the hand cuffs..gotta be careful when putting them onhaha I only wish! We were playing cops n robbers!
Hyde200
Gold Member
Ohh yess. Some people like carpets and alcantara seats and dash board... but this is more me! Makes me want to get the cage on order and get mine all done! Which compressor and gun did you use?
Bloody beautiful!
Bloody beautiful!
Thanks very much.
I have a good 150litre compressor and it's just a cheap gun. No need for anything expensive when you're not using them all the time. Think it was only a £10-£15!
My new material to make the footwell false floors has arrived. So will update with pics shortly.
I have a good 150litre compressor and it's just a cheap gun. No need for anything expensive when you're not using them all the time. Think it was only a £10-£15!
My new material to make the footwell false floors has arrived. So will update with pics shortly.
Well while I can't do anything much at the moment I've still managed to make some progress. I've ordered a load of new parts from Helix, Forge & TTV. I've also dropped the gearbox off for a check over and for an uprated 3rd synchro ring before it goes back in and also sent the front subframe off for shot blast and powder coat. Some progress at least!
Hyde200
Gold Member
I still believe we require more interior shots! haha.. Which foot plates did you go for and how are you going to be fixing them mate?
Haha more to come shortly!
I've bought phenolic board and am going to make a custom fitted set to my own spec and dimensions. I had thought about ordering the carbon fibre ones you can get from carbotec as I had something similar before in my 106 but decided against them.
Hyde200
Gold Member
Would be good to see some of your designs/mock ups for them. For the moment I have just bolted in a bit of sheet aluminium which does the job, but I don't like the look of it and I'm pretty OCD even with a bare metal interior!
Anyone know where I could pick up a complete Sadev ST-75 Cup Racer gearbox set up?
Similar Thread Suggestions
| Thread starter | Similar threads | Forum | Replies | Date |
|---|---|---|---|---|
|
Engine options for a Clio 197 | Clio General Chat | 6 | |
| K | Clio gear stick size | Clio General Chat | 1 | |
|
For Sale: Renault Clio 197 R27 F1 Team | Clios For Sale | 3 | |
|
200: Clio 3rs 200 difficulty changing gear at high revs? | Clio General Chat | 2 | |
| S | 2010 Clio CUP - UPC | Clio 200 Area | 1 |