Swapping the Badges for CF ones

[Tom]

I have some new CF badges on the way and wanted to know how to make the change.

I've found some useful posts, but I am not sure 100% that all the replies are what I am after.

Front badge: I do not have small hands, so it is a bumper off job for me. Got that.

Side bullets: I saw that Jase said to just remove the repeaters and slide them back. However, there were a few replies following this that said it could not be done that were not cleared up.

Rear Badge: I saw that you can just pop it off. Really?

My sources:

http://www.clio197.net/forum/showthread.php?t=5326
http://www.clio197.net/forum/showthread.php?t=4632
http://www.clio197.net/forum/showthread.php?t=4545

I would be really grateful if someone could clear this up for me.

Tom.

 

[Nick.]

Yes the rear badge literally just pulls off, you have to use a bit of force, i wrapped a terry towel up and used it to rest a small flat head screwdriver on to prise it off, just be very very careful around the paint, you might be able to to it with just your hands, but there are 4 like studs behind either face of the badge that press into rubber holes.

 

[Tom]

Yes the rear badge literally just pulls off, you have to use a bit of force, i wrapped a terry towel up and used it to rest a small flat head screwdriver on to prise it off, just be very very careful around the paint, you might be able to to it with just your hands, but there are 4 like studs behind either face of the badge that press into rubber holes.

Interesting! Thanks for clearing that up!

Anyone got any info on the bullets?

 

[Bic]

Hi Tom, as you say cabove, slide repeater back, the bullet will slide back and pull out. Yiour badge set is going to lacquer this week, will be out to you fingers crossed back end of the week.

Thanks

Chris

 

[Tom]

Thanks Chris.