Replacement sunvisor mount covers - who would be keen for some?

[krappy]

I have designed some 3d printed replacement sunvisor mount covers for the commonly broken ones on the Clio 3.







Main body of the cover clips onto the mount and the small infill panel then clips onto the cover, which allows the cover to be removable should it be required.

These are 3d printed via laser sintering (SLS) in Nylon PA12.

I believe these only come in one colour from factory (like a beige grey), so will be offering them painted to match the factory interior colour.

Final price is dependent on numbers as I need to outsource the printing in Nylon PA12, and the more that are done the cheaper the price per unit, so would be good to get an idea of the level of potential interest.

Let me know if you would be keen on a pair If they were made available.

 

[DS197]

I’d buy two sets (one painted and unpainted) as the plan is to fit a black headliner at some point.

 

[krappy]

Thanks @DS197

 

[Dannycowley]

I’d be interested

 

[Grinchly]

I'm interested in a painted set

 

[krappy]

Thanks all for your responses.

Firstly, I apologise that I neglected to mention that I am based in Australia.

Re: price - based on the interest shown on here and elsewhere I would be looking to offer these covers painted to match the interior colour for $50AUD a pair + fees/postage ($50AUD is approx £26 @ current rates)

(I would have liked the price to be a bit lower, but couldn't get the printed price per part as low as I had hoped - the level of interest wasn't quite high enough to justify a larger print run)

As I am based in Australia, postage is obviously going to be a bit more expensive than normal - minimum postage cost would be approx $29AUD/£15. But if there were a few of you who wanted them and someone was willing to act as the receiver, then the postage cost could be reduced by quite a bit per pair.

@DS197 @Dannycowley @Grinchly - let me know if you would still be keen now that you have an idea of cost.

Cheers

 

[DS197]

Hi mate, I’m still happy to buy at that price as well as act as a receiver and post out other people’s trims if needed.

 

[krappy]

Thanks for that @DS197 - very kind of you

I have pressed go on a printed run of the covers - will update again once I have them and they are painted

In the meantime, if anyone is keen on a set and are wanting to share/reduce postage costs then might be worthwhile getting in touch with DS197

 

[SRX600]

@krappy @DS197 I would be interested in a painted pair.