poor exhaust fitment?

[toop182]

Hey since I've had my 200 with ktec exhaust, everytime I hit a bump the ehaust clonks of something, and if there is someone in the back it sounds like its whacking the rear axle beam, has anyone had this problem and will harder exhaust rubbers help in any way? Quite embarrassing in car parks

 

[Foxspeed]

its probably the diffuser or exhaust collectors on the diffuser

after a few heat cycles and miles the exhaust will have "settled" and sometimes they can just touch in certain areas - it may take a few goes to position it right

 

[Sanders]

Mine does this also

 

[henderson]

took me 6 goes to get it right,it'll be banging on the body work just above where it exits the diffuser,the original tail pipes are angeled down to the floor but with the diffuser on you'd never notice that,you need to recreate that to make more room above the tail pipes,like i said it took me ages to get both pipes even,the smallest adjustment alters the angels alot,good luck

 

[Ashton]

the only banging i get from my Akapovic is on upshifts at 7000RPM

glad i paid for the quality of the Akro - i have had Milltek, Piper etc in the past and i was always adjusting them. they drove me mad

 

[henderson]

took 2 hours to set and sounds awesome,going on a cheap holiday with my extra money! bottoms up!