Search results

Just get some bolt sleeves and cut to the required length and nut rivet the floor pan. Bolt goes through the carbon footplate in through the sleeve and into the nut rivet to secure.

Depends what you are after. Spacers obviously will give you the stance look you may be after but remember longer bolts are needed too. A wider wheel will allow the option to run a wider tyre to be installed but will gain extra weight in some cases in wheel & tyre. Cup racer 8Js weigh around the...

You meaning offset or width of wheel like 8 inch from the standard 7.5?

If removing rear seats in theory you must remove all seat belts corresponding to that seat, otherwise it could fail having seats missing. You may get an advisory stating the rear seats are missing. Just bare that in mind if fussed.

Great project & build. Which seat side mounts & base are you using?

I came and viewed it originally. Tidy car

10.2kg

I have 4x Cup EE brackets if anyone needs them. DM me if interested.

Congrats. You had the blue and yellow 172 right? :wink:

Same calipers yes but different mounting points & brackets on both Maxi variants.

Anyone from here? I see it often parked outside Screwfix

Thanks. From removing the back seats I doubt you will feel any real difference in balance unless you are pushing the car and looking out for it. On this occasion my Clio was already stripped when I bought it so can't comment on what it was like before. It does however like to oversteer...

Not finished the build yet. Are they ever finished thou? Engine is standard currently with the aid of the R3 Carbon airbox. I am strong believer of saving weight where I can first before plowing into costs for engine upgrades that sees very little gains on a N/A engine. Weight is unconfirmed as...

Hard wire to an Auxiliary cable in the car. This will allow power to get to the camera unit 'only' when the car is unlocked and active, similar to most 12v cigarette lighter sockets found in cars. You can feed a mains off the stereo system. There's Aux power there and simple to get to.

It's sat on my desk as a reminder to take mine apart. The Part is not expensive. Part Number 3rd Gear Syncro: 8200 641 529 - £22.20+VAT

Here is pics I just took for you - 3rd gear Syncro. Been sitting on my desk for over a year. Confirms they revised to a steel.

Unsure, not had it tested yet. Next year i shall know but I believe around 105db

Awesome Job!! Nice to see it being done proper. Enjoyed reading up on your build. You are making me rethink on parts of my build now, although I'm nowhere near finished yet.

Hi, they are Carbon Fibre foot rests taken from the Clio R3. You can get cheap similar ones in Alluminium on eBay or even carbon. Take a look.

Sorry, not been on in a while. Yes that was me ;-)