Search results

That what your using mate?

Thanks, are they as good as genuine pins anyone? Good price for 4 at £15 with plates. Anyone know who? Cheers

Anyone?

Taking my calipers off for a full paint and seal refurb. However the pins on the fronts, are completely seized in. Soaked them in WD40 but they just will not budge not even slightly!! How for the life of me are you supposed to get them out? . . Probably going to have to cut them and then buy...

Get my PM mate?

I had exactly the same issues. Lines were too long. Didn't realise at the time of fitting that they would rub on the arch liner. Started getting a knocking noise and when I investigated found it was just them hitting on full lock, damage and wear to braid was bad though so I had to remove them.

Cheers for replies, Jake where did you get your decals mate?

Hi guys, Currently stripping all of my calipers to give them a service, replace all seals etc. During this time I'm going to get them painted by a local bodyshop. They have done calipers before and have seen photos of there work. R8 calipers and a few Range Rovers. I asked them about Brembo...

Got a pair of Black 197 Cup Handles which I would I would like to fit to my Black 197 (replacing the silver ones). I know they are not compatible with keyless entry, not too bothered as both my sensors are very temperamental. I just wondered if by removing these handles, and unplugging...

Welcome to the site mate!

I have the snowflakes on my 197, I believe it to be down to stress on the plastic over time. The short time I had a HID kit fitted didn't help either and increased the markings. . . possibly caused by heat?

They are terrible! Amount of chew I had to endure over my steering wheel (melting) warranty claim was unreal!

Are these genuine projectors guys? http://www.ebay.co.uk/itm/Renault-Clio-197-Projector-Headlights-/201007298121?_trksid=p2047675.l2557&ssPageName=STRK%3AMESELX%3AIT&nma=true&si=R4fUUFDLuUBAL71rONwowedP8DY%253D&orig_cvip=true&rt=nc

Yeah mate reflectors, wanting to make front end better. They are at a significant reduced price with the part numbers I posted. Think i'll buy them anyway and work out what I need afterwards . . .

So the projector part numbers I posted mate, are for Xenon bulbs? Still confused as to what I'd be potentially buying :$

I'm wanting to buy some Clio 197 proejctors, and have messaged Steve Murr. Are these the correct part numbers to fit a Clio 197 - 2006? OE number:7701061075 / 770107049. Slightly confused between talk of two different types, some with xenon/loom which are harder to fit? If someone could...

I personally would be looking for around the 300bhp mark. . .

Been reading more and more about the whole Megane engine conversion process. 197 is now off the road for the winter and I have been actively looking around for a potential engine to buy and build up over the winter. Figured I'd start a general thread to gain further information from people who...

Chris, I have just started using your guide for the front calipers. I've just put up a similar thread relating to rear calipers, where did you purchase the rebuild kit from?