Search results

Bit of a random question I know. The past couple of weeks I've had a couple birds poo on my car. Whenever I notice any I always wash it off straight away so it doesn't stain. This time it must've been on there for about 30 minutes and nothing I try will fully remove the stain mark. I tried...

I changed them to white. Maybe I should do a small write up of how to do it. Couldn't find any information online of how to change them on the mk3 so just had to go for it Sent from my SM-G950F using Tapatalk

I did figure it out in the end [emoji16]. I got two spoons and put them under the needle and used them to evenly pull them off Sent from my SM-G950F using Tapatalk

Thought I would put this in the general chat as it applies to the 197 and 200. I'm changing the LEDs in my speedo but before I go ripping off the speedo needles and messing something up has anyone removed them before? Can't find any information on removing them for the mk3. Normally they just...

Did the service message start flashing when you held the button down on the wiper stalk? Sent from my SM-G950F using Tapatalk

You arent going to see any performance gains from doing it but you will get a bit of sound difference (not much) The blanking plug you sent would be for if you were to remove the valve completely from the engine bay. That large pipe that the blank goes over is on the side of the air box and...

Engine on with small pipe connected (valve shut) Engine on with small pipe disconnected (valve open) Sent from my SM-G950F using Tapatalk

The way the valve works is from pressure from the small pipe on top When the engine is running the valve is closed but when you reach a certain rev range the pressure will push the spring inside the valve and open it To make the valve open all the time just remove the small pipe that goes from...

I have disconnected the small pipe going in the top of the valve and I'm pretty sure that's all you need to remove. I believe the valve is normally open until the engine is started and then the pressure through the small pipe closes it and it wont open until the revs have built up enough to...

I would say https://www.renaultpartsdirect.co.uk/ But looking on the website I can't see the parts you're looking for but you can always give them a message Sent from my SM-G950F using Tapatalk

Where are you located? Sent from my SM-G950F using Tapatalk

Hope this helps a bit. It was a long time ago since I did it. The clear gel stuff was a little bit of silicone sealer I think just to make it a good fit Sent from my SM-G950F using Tapatalk

I've replaced the o rings inside to slightly thicker ones. They seem to keep it pretty secure Sent from my SM-G950F using Tapatalk

On start up mainly in the cold my car makes I whining noise for about 20 seconds then it fades away It made the noise when I got the car and I didnt really notice it until my neighbour pointed it out I've had all my belts changed about a year ago when I got the car. I just assume its something...

Do you know the cost to get it repaired? Has anyone had the rust patch and got it fixed? I'm thinking a body shop could probably spray the lip where the water sits rather than spraying the whole boot Sent from my SM-G950F using Tapatalk

I've got a little rust bubble on my boot as well. Thought I was the only one Didnt think the corrosion warranty covered something like that. I guess my warranty would be out as well seeing as it's a 56 plate Sent from my SM-G950F using Tapatalk

Doesn't sound like you've had much luck with renfault clio so far I've had a couple problems with mine within the year of owning it but I think it's all just age related things and it could happen to any car. The manifold flexis was one of the issues that was quite a big pain to do and the ball...

I undo the 2 nuts that hold the acoustic valve in place (the trumpet shaped thing) and then fully remove it to get better access. Unfortunately theres no other easy way Sent from my SM-G950F using Tapatalk

The problem isnt that bad and the mot is next week so I'll see I haven't had the engine light flash on for about a month now but it still doesn't sound 100%. Unless this is just how the idle is meant to be Sent from my SM-G950F using Tapatalk

So ever since owning the car (about a year now) I've noticed it splutter on idle. You can hear it clearly when standing behind the car and the exhaust note goes up and down and you hear little pops and chuffs (very technical vocabulary I know) I've had an engine light come on a few times and it...