Gearbox mount

[Legend@wheels]

Hi
Im about to change my gearbox mount ,there is only one right? I hope i didnt miss any .
Plus the way to do that is:take off battery and its cover =access to top of the mount ,then remove the under tray = access for bottom of the mount to put one jack stand to support the gearbox ,step 3 unbolt-remove mount -refit mount bolta ,and refit all the rest?
Am i missing something?
Regards

 

[fano45]

you dont need to remove the undertray. you can support the gearbox through the vent hole in the undertray. once you remove the bolts the mount might not budge. use the jack to move the gearbox up and down slightly. this will work it loose.

 

[Legend@wheels]

You sure this small spot in the under tray is enough to support it?(even If i replace the bracket too)
I think to put the jack stand on the end side of the gb(where the mount is ) would be better
I use jack stands to lift the car too i hope it will work in harmony

 

[fano45]

i meant a 2ton trolley jack

 

[Legend@wheels]

Good idea ,maybe i wont even need to lift the car and put it on stand jacks.
(As long as the trolley jack will get under the car smoothly)