Latest activity
-
I have the PMS mounts set at maximum castor +7.3 degrees with camber -2.4 maximum camber without cutting the strut towers. The extra... -
I didn’t notice much of a noise change on the V6 box, but possibly because the exhaust was so noisy. Car looks unreal. -
Final bits today. All the trims put in and lower trims cut for the cage, could do with a bit more fettling but it is good as it is...
-
Onrus replied to the thread Glacier White 200 Cup.I have the PMS mounts set at maximum castor +7.3 degrees with camber -2.4 maximum camber without cutting the strut towers. The extra...
-
We drove the car over to AW Motorworks today to get the Clio aligned so it would drive straight at Snetterton on 28th September after...
-
Final bits today. All the trims put in and lower trims cut for the cage, could do with a bit more fettling but it is good as it is... -
Sean197 reacted to KoZa's post in the thread Clio 3 RS F1 Team R27 Meglio - it will be a trackcar with
Like.
Fitted :) -
Tturkie172 replied to the thread Dead 197 - Electrical Issue….CONNECTOR NO (BLACK) Small Clio 2008 without Xenon Lights
-
-
Tturkie172 replied to the thread Dead 197 - Electrical Issue….
-
-
burrellbloke replied to the thread Glacier White 200 Cup.We drove the car over to AW Motorworks today to get the Clio aligned so it would drive straight at Snetterton on 28th September after...
-
-
OOilydan replied to the thread Dead 197 - Electrical Issue….Well, reconnected everything and problem persists as before. Anyone got a pin out diagram for the ECU? Can only fine diagrams for the...
-
-
Ttusk19 posted the thread Torque setting for ring gear to diff? in Engine, Gearbox, Exhaust and Air Intake.Hi, I'm just fitting a diff and I can't seem to find the torque settings for the ring gear. Any help would be appreciated Also do I...
-
