Stud and Nut conversion

Discussion in 'Wheels and Tyres' started by Big Ben, Apr 19, 2018.

  1. Dan-

    Dan- Paid Member

    Messages:
    205
    Location:
    Brentwood
    Car:
    Clio 200 Cup, BMW 330E
    Just nip the studs up, then do the wheels up to usual spec. Don’t undo the wheels for a few hours but best leaving over night to let the loctite set
     
    N0ddie likes this.

  2. suj

    suj Paid Member

    Messages:
    879
    Location:
    Birmingham / Warwick
    Car:
    Nimbus Grey 197
    20-25lb/ft on the stud, then as said torque the nuts to normal wheel bolt torque and leave untouched for the loctite to dry.
     
    N0ddie likes this.
  3. Big Ben

    Big Ben Winner - POTM February 2018 Paid Member

    Messages:
    5,660
    Location:
    Herts
    Car:
    197
    The studs have a little shoulder flange on them. Just do them up until they’re tight on the shoulder. I torque nuts to 125
     
    N0ddie likes this.

  • Share This Page


    1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
      By continuing to use this site, you are consenting to our use of cookies.