RS200 CUP Wheel Bolt Torque

[beaks]

I'm sure this will have been asked here before but I can't find it in the search bar -

What torque should I be using for my wheel bolts?

Thanks in advance all

 

[burrellbloke]

I do them up to 130nm.

I think some documentation suggests 140nm.

If you have locking wheel nuts do them up to about 110nm otherwise you are likely to damage them.

 

[beaks]

I do them up to 130nm.

I think some documentation suggests 140nm.

If you have locking wheel nuts do them up to about 110nm otherwise you are likely to damage them.

thanks very much bud - appreciate your quick reply.

makes a nice change for the generic 'FT'...

 

[R20BTG]

I do them up to 130nm.

I think some documentation suggests 140nm.

If you have locking wheel nuts do them up to about 110nm otherwise you are likely to damage them.

I do exactly this too ^