Milltek on 197

[kevinevo7]

Hi,

How far are the tailtips of the Milltek on a 197 sticking out of the back?

Or does a Milltek for the 200 fits on a 197?
I prefer the OEM look.


Thanks,

Kevin

 

[MikeH]

This much

 

[kevinevo7]

Looks good.

I'm going to book it for a remap and exhaust.

 

[carbonfanatics]

Be prepaired for a melted diffuser!! Fine with the Miltek tips on but if you go back to STD you will see where its been

 

[gaz]

I'm toying with a 200 Milltek and get some slash trims made up to fit.

Pea shooter ftl

 

[Holynez]

Be prepaired for a melted diffuser!! Fine with the Miltek tips on but if you go back to STD you will see where its been

Do you know of anything to prevent the melt down and what sort of damage is caused?

 

[henderson]

Do you know of anything to prevent the melt down and what sort of damage is caused?[/QUOTE

the exhaust hangers bolt to the car at the rear under the diffuser,put washers between them and the car to prevent this,it drops the exhaust down by however many washers you put in but i'd say about 10mm is about right,i used 3 penny washers per bolt

a tip i learnt from a certain Mr Foxspeed