Corbeau Clubsport buckets with standard seatbelts

[MattStevo]

Hi all,

Has anyone fitted corbeau clubsport bucket seats using the standard belts into a 197? Does the belt fit through the holes in the bolsters?

 

[RichCUp]

You need 106/saxo rear seatbelt buckles as the standard seatbelts are fitted to the seats. You could technically remove the standard buckles and chop the wires but prob best not to.

You can run one side through the hole in the side of the seat by removing the seatbelt bar (which runs parallel to the floor) then looping the belt through and re-attaching it to the bar. See this page for an example:

https://clio197.net/threads/ultra-red-clio-200-project-clubsport.55884/page-12

 

[MattStevo]

You need 106/saxo rear seatbelt buckles as the standard seatbelts are fitted to the seats. You could technically remove the standard buckles and chop the wires but prob best not to.

You can run one side through the hole in the side of the seat by removing the seatbelt bar (which runs parallel to the floor) then looping the belt through and re-attaching it to the bar. See this page for an example:

https://clio197.net/threads/ultra-red-clio-200-project-clubsport.55884/page-12

Thanks alot mate!

 

[RichCUp]

No worries! Btw I meant the standard seatbelt buckles are fixed to the seats not the seatbelts themselves!