Alignement values with h&r springs

[p4l0m0]

Hi there,
I've upgrade the cup chassis with h&r springs. After that i have this values:



What do you think ? I feel the car goes fine but can't feel the out wheel pushing in the corners as before...

Sent from here

 

[p4l0m0]

Anyone?

Sent from here

 

[PAUL JA]

Have a look in post 3 for Reno settings

http://www.clio197.net/threads/suspension-gurus-unite.54872/

 

[p4l0m0]

Have a look in post 3 for Reno settings

http://www.clio197.net/threads/suspension-gurus-unite.54872/

Are the same values for Clio III and IV? Thanks

Sent from here

 

[PAUL JA]

Sorry hadn,t spotted we were in the Mk4 section !!! cant confirm the settings are same

@Womble - Ian do you know ?

 

[Womble]

Sorry hadn,t spotted we were in the Mk4 section !!! cant confirm the settings are same

@Womble - Ian do you know ?

Too much toe in, back it out a bit and the car will feel a bit more keen, I run 0.5 mm toe in feels good, not sure what that is in deg I just tried 0 and tried 1mm and 0.5 feels the best.


Sent from my iPhone using Tapatalk

 

[p4l0m0]

Sorry @Womble, I'm not sure if understanding you. What do you mean with toe in? Thanks

Sent from here

 

[PAUL JA]

Sorry @Womble, I'm not sure if understanding you. What do you mean with toe in? Thanks

Sent from here

Front toe in reduce it to 0.5mm or try 0 deg 10 mins total

 

[p4l0m0]

What is front toe in Spanish? Which value does it correspond?

Sent from here

 

[PAUL JA]

Convergencia ?

 

[p4l0m0]

Ahhh OK

Sent from here