Search results

No track days. I like to drive hard on the road sometimes ;) but that's about it. aa

Afternoon, I went to change my front brake discs and pads this afternoon and noticed that the rubber seals around the pistons have some bubbles in (see picture) I have decided not to change the pads and disc just yet as I may aswell replace all the seals at the same time. Why would these have...

Afternoon, I currently have a set of DS2500 pads which I fitted 3000 miles ago (still have loads of meat on). I recently purchased a set of USED KTEC Black Edition grooved discs that had covered approx 300 miles. My current discs are shagged. Obviously I want to put the new discs on but know...

Phillips SilverVision Indicator bulbs. Make sure you get the ones with offset pins or they won't fit.

4 Years IIRC

Fuse box on the right hand side of the engine bay. Under the secondary air intake "trumpet". One of those has blown.

Welcome!

Welcome along

Just Renewed with Adrian Flux. 24 Years Old, 5 Years NCB. All Mods declared for £425. No one else got close to this.

They were a new set of DS2500 in Febuary. Covered about 3k on them, will be rather annoyed if they are ruined. I'll have them out at the weekend and check.

Over the past few weeks my car has developed a squeak from front left wheel assembly. At first I though it may just be a stone in there and it will eventually fall out. However the squeak disappears when applying the brakes and when the wheel is turning. Any ideas as to what this might be? I'm...

Morning, I am fitting my new Ktec Cat back this week and after reading about other peoples experiences re knocking and melting the diffuser I want to make sure I get it right first time. Is the knocking obvious when driving? Where does it knock? Alignment tips? Any help/advice would be...

Can someone (Mod) change my vote to "K-Tec (2 Rear Silencers)" please.

Just purchased a Ktec Cat-Back off here. Are they a pain to get fitted correctly ie not touching the diffuser?

Great spec by the looks of it. Enjoy!

Welcome along :)

I've recently had my exhaust manifold welded back up and all the welds strengthened. Will fitting the Polyflex Engine Inserts (All 3) put added stress on these welds as a result of the added vibrations?

Just got back from my mechanic and he did all types of checks on it. The problem is now sorted, think it may have been just a 'dry' connection.

I plugged my OBD fault code reader in and just out of curiosity searched for any fault codes. No engine management lights have come on just did it to see if there were any. I was presented with P0325 which I googled and it pointed to the knock sensor. I have a Ktec Induction kit and Polyflex...

Welcome along :)