Search results

Hi - I have already just done the same thing with my track car and removed the whole air distribution unit - I cut the pipes in the engine bay that lead inside the car to heater matrix and then I used alloy blanking plugs. I haven't joined the pipes as didn't think this would be an issue given...

Easy Composites are worth a look

I am going to be removing the whole heater/air distribution unit soon from my 200 track car. Just wondered - does the unit have its own heater running its own water that it heats or does it use hot water from the coolant system. Just asking so I know when I am disconnecting it all will I lose a...

Cheers - so did you just cut a hole for the stop/start button? Does yours have the slight indent still for where the radio would go and it just doesn't show up very well on the pictures or did you get it made flush without it?

Hi, where did you get carbon centre console from? Does it still give you access to key card slot and connector to allow diagnostics/remap?

Does anybody know what the sensor is actually used for...traction control, ABS, speedo etc? Need to know what knock-on affect binning these wires will have. Thoughts from somebody who has already fully stripped their 197/200?

Yep that's it....cheers. That drawing is very useful. Do you have the full wiring schematic with associated references i.e. what all the numbers mean or is it on this site somewhere? Would be very handy to have as I complete my strip out.

I posted this in the interior section and got very little response...I know that might mean nobody knows the answer but thought I would try and stick it on general. I have a 200 track car which is pretty much fully stripped now. I have already removed some wiring and am now trying to finish...

Would have thought ABS only worked on front brakes so strange place to put sensors towards back of car? Anybody know somebody who has stripped a 197 or 200?

I have a 200 track car which is pretty much fully stripped now. I have already removed some wiring and am now trying to finish the job. Just wondered if anybody knows what the cables/wires are that are running in to the rear wheel arches. The attached pictures are from inside the boot and it...

I'm in North West - Lancashire

Already changed oil - that was my first thought.

I have a 2012 Clio 200. Gearbox was replaced under warranty when second gear crunched. Car now out of warranty and gearbox making a strange noise when barely under load (so when just gentle throttle cruising at say 60mph). Gear change is fine so could be bearings or something to do with preload...

Anybody know if CM Composites are still going? Chris has been making a part for me but I can't raise him and the website seems suspended. Cheers, Ian.

Ryan I have the Oreca system too - where did you get the unsilenced decat pipe from?

I would also be interested to know what you think of it.

Do you have a part number for the aircon delete kit - cheers

Just wondered if anybody had ordered wing mirrors for Clio Mk3 from MC Racing and if so what you thought about quality and fit/install. Link is below...

That's it - cheers.

Thanks but that's not the one. The console I saw had the cut outs for the start/stop button and door lock too...just not the radio. Anybody else remember it?