Sean197's latest activity
-
The driver side inner cv boot had a few pin holes and was leaking so fitted a new one while I was there,luckily all thats holding the... -
Got the gearbox welded from a hot rod shop nearby,i think they done a pretty good job and only charged 70£,it's welded on the other side...
-
Clio197
-
I have reviewed the process and gathered all the necessary components. The airbox behind the dashboard requires motors, a sub loom, and...
-
Sean197 reacted to Marsch's post in the thread Various pics of my C3RS "Sport Auto Edition" with
Like.
Not much going on with my Clio. Prepared it for TÜV the last weeks. I had to change a light bulb (left/driver side) and had to... -
Sean197 replied to the thread Intake manifold sensor.
-
-
Hey all, first time Clio owner here. I’ve come from a RWD background (predominantly M3’s) I used to own a MK1 Golf GTI and always wanted...
-
It’s been ages since I tested one, but I’m pretty certain of the 2 I’ve done, both were ‘low’ like yours. Both made good power on the...
-
did you spin it over the same time for all cylinders and make sure the throttle was fully open?
-
Feel bad lack of updates works busy, family holidays etc had the car out the unit for the weekend and started getting the dash...
-
Couple of pics of last weeks trip to Le Mans. If you’ve never been I’d highly recommend it!! :french:
-
Sean197 replied to the thread Low compression?.Put a few drops of oil down and redo a 'wet' compression test. If the figures rise then piston rings are the likely issue, but your...
-
Well I ain't on bookface, but this place has been super helpful to me since I got my Clio 3 - hopefully it can keep going as it is a...
-
Nik might log into cliosport but aside from the CSF thread I've not seen him post for ages. It is a shame this place has been abandoned...
-
Forums are old school, but good.
