Recent content by LB197

Very trivial but I'm putting the car back to an "OEM+" kind of look for a bit, I see Renault archive files flying around on here and wondered if by any chance someone knew the proper positioning, spacing etc. of the CLIO and RENAULT SPORT badges on the boot lid. If they aren't in the right place...

Just read through, thanks a lot. Few things to check there

Unfortunately not, I had that trouble with my mk2, I might as well of just took the glass out Thanks though

Hi, I’ve noticed a leak inside on the passenger side. At first at the front but seems to have moved to the back. There seems to be a little water on the door seal (down near the bonnet release, but doesn’t look as if it’s coming from there really based on where the water is. I cleaned out the...

Got a bit fed up of these door rubber strips, even bought some genuine ones and still fell off. So just got some cheap door seal tubing off eBay and works really well.

Some setup that, i dont think my girlfriend would let me get away with it though [emoji23] ive just about got printer in the house haha. I’ll give abs a whirl next then, the PLA has held up under the bonnet but i reckon in the summer it’ll do a flop [emoji23] ive had a few things even small...

Thanks, im doing a few tests with it. Few bits in the garden to test how it handles water when it’s printed and a couple of bits to test the heat, more so i know myself what i can get away with like. I wanted to bend something and only took minimal heat to bend I’ll get a couple more reels at...

Good shout, should be able to get something together for that. Mine isn't too bad as I just gave it a wire brushing and sprayed it. Yeah, that's something I've thought about, it's just how to go about it as they would still need to be quite deep or I'll get my toffee latte everywhere like it...

So after some meddling round, ive got the hang of fusion 360 and cura suj thanks for that recommendation saved me searching for and trying other free options. Turned out to be an ender 3 pro, so has a few benefits over the 3 at least. Made a few little house bits and then wanted to move onto...

Perfect! Thanks for that, I'll have a look. Totally understand on the "not want to give away hard efforts", worth an ask though haha. It's an Ender 3, that someone I know is getting rid cheap, so not super current but good to get a feel for it. I'll have a play around and see what I can come...

-- If this post belongs elsewhere, by all means move to where it should -- Hi all, Should be getting a 3D printer in a couple of weeks and wondered if anyone has any images of past Clio bits they've done. Got a few ideas myself but would be good to see other ideas. Cheeky question, but if...

With the RS kit, I just bought the front lip from Renaultpartsdirect, someone may have just done that but got the whole kit. I've also always had good experiences with Diamond Motors.

Been a long time since I was on here but thought id add a couple of phone pics, made a few changes and cleaned the callipers as best I can, mainly going from the K-tec cup replica spoiler to a GT spoiler (Wrapped it black to match, as I wrapped the roof last year but thinking of taking that off...

Many thanks for your comments, got the parts and took it to a garage, far too bloody cold to be outside [emoji23] he showed me the old one and had a huge hole in it. Got both sides to be on the safe side.

Thanks for that, hoping its not a case of having to replace the rear disks again. Far too cold for outside tasks, I'll take it to the garage :tearsofjoy: