Hi everyone
Hope I'm in the right section, I have aquire a clip module and managed to install the software.
I'm trying to use it to diagnose a check emissions warning but when I run scan tool it just stays on "wait connecting" once the green bar is full.
Does anyone have any advice on how to use this properly? I have tried searching and Google but come up with nothing!
Thanks
Hope I'm in the right section, I have aquire a clip module and managed to install the software.
I'm trying to use it to diagnose a check emissions warning but when I run scan tool it just stays on "wait connecting" once the green bar is full.
Does anyone have any advice on how to use this properly? I have tried searching and Google but come up with nothing!
Thanks
