Hi all could really do with a point in the right direction. I have just fitted some cobra buckets and loving them however I have been left with the air bag light on as expected.
I did not expect to be this stumped by it! been down the local dealership in hope to get it turned off by using the clip software (i have read all the threads i can find) they said they would have a go.Well a bit of miss communication later they had locked the airbag system which leaves the light on and all the bags disabled any way this was not what I wanted to I asked them to revert it back so £35 in the hole and no where. they then said they could not turn off just the seat bag safety reasons etc.
I am now looking down the resistor route but cannot figure out which wires do what. I do know that they need to be about 0.3ohms but that's about it
any help is appreciated
I did not expect to be this stumped by it! been down the local dealership in hope to get it turned off by using the clip software (i have read all the threads i can find) they said they would have a go.Well a bit of miss communication later they had locked the airbag system which leaves the light on and all the bags disabled any way this was not what I wanted to I asked them to revert it back so £35 in the hole and no where. they then said they could not turn off just the seat bag safety reasons etc.
I am now looking down the resistor route but cannot figure out which wires do what. I do know that they need to be about 0.3ohms but that's about it
any help is appreciated