Search results

Looking for a turbo car. Something I can chuck around a corner. Budget is around £15k. Must have a nice interior. Not a megane. Prefer a DSG gearbox. Any ideas guys?

Hi there, I have a 200. Was sat in traffic and the check Injection light came on. Then went to put my foot down and it came up with Injection Fault. Now every time I start it, does the same and goes into limp mode. Anyone got any clue what's happening? I've plugged it in and nothing seems to...

As above. Have a black 200 which makes it impossible to clean and dry ): so what's the best? Thanks

Okay so I've heard I need a custom wiring loom, customer engine mounts to do a Megane conversion. 1st question is where do I get them from? 2. What else do I need and roughly what cost am I looking at? thanks :D

As above. What snow foam do you guys use and wheel cleaner on diamond cut alloys? thanks!

Does anyone know how to fit Citroen washer jets? They fit in but at a right angle to where they should be so does anyone know how to fix them onto a 200? cheers

So I took out the battery gray, induction kit etc and there were 3 bolts holding the gearbox mount in. I undid the 2 either side and then the middle one and tried to get it out. There was no movement... Anyone got any ideas on how to fit this or what I'm doing wrong?

Anyone know what and how many resistors to fit after fitting a bucket seat. They're up and running but the Internet has given me such a range of answers. Cheers in advance.

Clio 200, today fitted 2 sparco seats however found out I can barely see over the steering wheel. What do people use to make them higher? cheers.

Okay so yesterday I picked up 2 bucket seats and harnesses and I was just looking and can't find where to fit the bottom 2 points. Can anyone help or link a guide that may help me out? Or pictures of their points? cheers.

So to my earlier post I have a lot of people recommend the bilstein and was just wondering whether it would be stiffer and better than my current KW V1. Anyone had anyone experience? Stiffer as in harsher on the ground :D

Opinions as to which one I should get? Reviews say both are good but personal opinions? cheers.

Fitting Clio 200 parking sensors and just wondering what colour the reverse light wire is? anyone know? cheers.

I am fitting projectors for my 200 and the headlight adjustment connector is different. My old ones were 3 pin and this is 2 pin. Can anyone help as I need them done today :/ cheers!

Hi there. Have a 200 and today fitted new kW v1's. Question is, I need shorter drop links for it. Does anyone know which ones or have had experience with them? They're wayyyy too long to be honest :/ also anyone know how to fit the rear dampers. I know you need to drill a hole but it still...

What do you guys this about these? http://www.ebay.co.uk/ulk/itm/351528426162 will they fit? And if they do... Will they look good?

I'm buying Peking sensors and don't know how to fit them. Is there a guide that can show me how to do it? I know there used to be one on here but can't find it anywhere...

I know the Clio is already very tight but I've been looking at having new strut braces. Rear, front upper and lower. Is it worth it and would people recommend it as it comes to almost £400!!

Does anyone know why both my reverse lights would've stopped working on a Clio 200. Does anyone know where the fuse is so I can check it? Thanks in advance.

okay so I've been looking at going to RS Tuning for the above remaps. But I've read quite a bit that pops and bangs will ruin your engine. Anyone got any reviews on their map or personal experiences with them? Any info would be great...