Search results

Hi all does anyone know the thread size for the rear damper? ( top of damper) is it m9x1.0? Thanks

Lost my 4 torx bolts to fit the abs sensor and brake line bracket on hub does anyone know what bolt is needed? Thanks

Hi all what’s the best way to bleed the clutch to ensure you get all the old fluid out? thanks

Hi all, Anyone got the part number to the steering rack captive nuts that fit to subframe? Picture for reference With thanks

Hi all, All my front end suspension including tie rod ends removed and I struggled a lot to get the standard arb bushes and blocks removed. I need some inspiration on whether it’s physically possible to install new arb bushes without dropping the subframe. Has anyone done this??

Considering changing my outer CV boots. Would you use the stretch type? If so which ones? I don’t really want to be knocking off the outer CV joint as I don’t have a slide hammer. Thanks

Can anyone tell me the size of the pinch point hole where the ball joint enters it? 16 or 18mm? Thank you

Hi all, Does anyone have any recommendations for new seals on the plastic top mount covers? Thank you

Hi all, I removed my ktec filter today as I was changing the gearbox oil and found that the filter is heavily worn. Surely it’s not supposed to be this bad after 2 years. Can you buy this separately or is there a better solution?

Well, I’ve decided to not only keep the Storm Grey 200, but to do a progress thread. In October, I purchased a storm grey 200. I have previously owned one racing blue 200 and one alien green 200 and i thought I’d have to complete the set, with arguably the best colour Clio, storm grey! It’s a...

Hi all, When removing the front, usually rusty radiator support, do you have to remove front bumper and both front arch liners? Any recommendations/tips on how to hold the radiators and washer fluid bottle up whilst changing it? Thanks in advance.

Hi all, i remember seeing a 200 with a piece of carbon on the paintwork placed inline with the Arch Vents? Who sells these? thank you

This will be my second time removing oil filter My first time was awful as the filter was still full of oil, so when I went to turn it off(filter) oil pissed out. Is there anyway of draining oil filter? Or making the job less messy? Regards

Hi all, Can someone do me a favour and measure there front brake lines. I've been supplied twice the wrong length by HEL. End to to end would be fine. Regards

Every time I go round a corner, my drivers recaro seat squeaks/creaks slightly. It feels solid and doesn't wobble. Just makes the noise. Any ideas?

The section from manifold to cat on my car is blowing. Is there a certain clamp to use? ( the one on the car is not standard. Is there a recommended sealant to use? Many thanks

As above? How do you remove these? Inc the ones on rear quarter. Regards

As most of you are aware the Clio synchromesh are made out of chocolate and seems to be a problem on standard n/a engines let alone Meg engines so how many of you are running Clio boxes with 270/300? And how long have they lasted? Or or is it not even worthwhile, and stick a Meg box in...

Right question got a full megane 225 and my 200 im planning to put the engine into my Clio. When mating the meg ecu with meg wiring and Clio, will it run straight away? Or do I need to remove my immobiliser or get it reset? From Clio? Or do I need CLIP? is there anything on the electrical...

As above really?