Search results

It will almost definitely be the exhaust. Sometimes a new maf sensor helps (if yours is knackered) but usually it's the extra exhaust flow making and less back pressure I put a centre silencer back in mine and it went away completely A good map is probably needed for exhaust mods

Worth considering that the shaped hardline with 10cm of braided hose on the end is only £35ish from Renault

Mine was hanging out my arch recently and I assumed it was some random shitr that had got stuck in there during some of the flooded roads we got with the snow . Now I know it but can't see me sticking it back in

Well I've worked out that the 4 hose kit only replaces the short body to beam hoses on the rear. What's the point ? Still have rubber hoses at caliper end ? Does no one make a 4 hose kit that goes straight from the solid line to the caliper ? So with a female din end and a male din end ...

Had advisorys for front to rear pipe and the pipe across rear beam on my recent MOT I've made and put on a solid front to rear pipe which goes from under pass seat into to the short hoses on rear beam Not sure what to do with the one on rear beam . New Renault pipe and hose is £30-40 so...

Don't happen to know the lengths of your rear hoses do you ? I assume they're going straight from the front to rear pipes to the calipers ,Removing the short hoses and pipes across the beam? I had an advisory for cruddy brake pipe that goes along the beam yesterday and have had braided hoses...

No heatshield off here. I did have a right carry on but it was December , I didn't have any string and I didn't jack the car up high enough Much easier to just pull it through like link says

I used a euros pagid one in about December and it fitted spot on

I'd be making a complaint and going to the ombudsman about the value they're offering. Where are they finding undamaged 200 cups for that price ? I'm sure there might be a couple but it's far from an average value. I was lucky when my MK2 golf got wrote off as they offered quite a bit more...

Yes i definetly recommend that ! I didnt realise it was a loose stud/bracket inside the subframe until it was too late

Anyone in a predicament who finds this post I removed the nut from the wishbone and pushed the bolt in a bit but not right through. This allowed me to get my finger in and tease this bastard bracket back into the hole Fun fun fun

Thanks I will have another go tommorow but I can't even see or feel it as things stand.

Got the exhaust manifold swapped on my 197 . Interesting job on the drive but it's in place and no more blowing One of last bits I've got to put back on is the subframe brace/stiffener . The one at front held by 4 x 16mm nuts However...until 5 minutes ago I didn't realise the studs where...

With the price of the soon to go rusty replacements it's pretty tempting to make/bodge one ! Need to get mine off again and have a look and measure

The guy from this company I've been in contact is great too by the way . Eddy I think . Kept me informed , offered a refund . Let me choose a custom colour/material combo not listed I'd recommend anyone ordering to send in their measurements like. Definetly soke confusion over the...

Mine had a rubber. Lost it. Just reminded me I need to buy the new one

Mine just turned over and over and over when the crank sensor failed . Didn't stop after a few seconds as you're describing Best thing is to plug in a decent diagnostics. Whatever the rac used told them my crank sensor was knackered and they where spot on . My pressure plate had smashed its...

Yea they're Definetly not welded on . Corroded on maybe as aluminium and steel but never not got them off with either heat or a ball joint splitter and hammer Like above its bad that they didn't notice how loose the new ones fit into the hub without the hat/sleeve

Snapped a bleed nipple off in my brembo but it must have loosened a bit first a and I didn't realise so lost a load of fluid Read somewhere that this will cause a problem for the abs module and it might need plugging into clip and setting to bleed ? Is this true ? Taking it as an...

Fight It. The 'engineers' report should say why they think it's too dangerous to be put back on the road but you can get a second report. If youre claiming off her insurance which you should be then you have rights and can make decisions. If gone through your own it's trickier