Search results

you can clay matte cars, just need to use the correct lubricate as many lubricants contain like silicone stuff to make it glide easier but leaves a slight sheen which is why it works on glossy cars, but yeah if you have a proper detailer im sure they wont mind letting you in a few tips or watch...

Clutch issue there, drive at low rpm or youll end up damaging your syncro's! sucks

I don't understand people on here, you do realise you oil up these filters and clean them regularly ? That's the whole point in it. You don't install and leave it there for years, you clean it with your special cleaning fluids and the oil up and leave to soak in then it's ready to install again...

mine is a 2010 ag200 made registered in May 2010 has an RS badge :) just check top mounts its easier to tell as like said it depends when its built, could have been built in 2009 and not registered until 2011 :)

My 200 is May 2010 model :)

cant see if this has been posted before, but I've heard there are various types of top mounts etc for suspension, how can i tell which mine are ?? thanks danny

was just out installing some graphics for work when i caught it out the corner of my eye. no reg sorry anyone on here?

its a good job if its your first go :D just get a stanley blade and make a pin prick hole and push air out :) yeah sometimes fairy liquid allows it to move but doesn't do much favor for the adhesive :)

WELL this is the thing, i knew in my head, if i did do something in anger to him id be the one getting done for assault so i used my brain over rage and took a video, police tracked him down and are in the process now of him paying for repairs under "criminal damage" did think about insurance...

just being picky, but i dont advise fairy liquid as it doesnt dry too well. i done mine dry, hinge it in the middle and peel back on side and pull to tension and apply :) use a sharp knife to trim edges. me being me i see a bubble in the above pic :D aha but thats me being picky and do it for a...

back panels usually are rougher than the rest of the car, rear kicks allot of road grime etc that sticks to paintwork, quick detailer and a claybar should remove this and many more imperfections. applies to all paintwork :)

have you tried to bump start it to get it running ? i had to do this for a month untill i found a fix.. Starter motor heat shield is worth a look as thats what mine was shorting out on. what had happened is the small bracket had snapped and kept blowing a fuse. fuse blown was a starter fuse...

if picture is correct on the ebay link to the matts it seems like the Renault Sport is on the wrong side of the matt, as that picture shows its a left hand drive car and logo is to the left not a right hand side car with it closer to the door if that makes sense :) just be careful with pressed...

spotted in Bradwell Abbey, MK i work just round the corner from you :D saw it the other week and just done some signs at group security and seen it there again :)

i have a matte black one also i recently done when i was bored, mine is 215mm measured at the ends which is just right for the sun, people say they can be chavvy but most people dont notice them unless you have some writing on it :)

had this happen the other day, i think its because they look sporty, other drivers have in there mind "race" or "chav" i had a very angry guy come up to my car after me overtaking cruising passed a lorry at 63mph so wasn't a fast overtake.. anyway got to traffic lights and they guy got out...

Momentum 99 for me :) all other fuels are all 98 ron just with "adding" things to make it sell better but deep down its the same stuff

was going to stop you and see what was up, was just being loaded onto the recovery truck. what was up with it ? i passed in my Alien Green 200 :)

I'm having a similar problem as far as the battery low and stop sign appearing whilst driving, you got any more info or had a diagnostics? i can only assume it's something to do with the charge system

.......