Search results

Plastics4Performance, perfect Quality! I have antistatic stickers, you can remove and reattach them as often as you like. You see the sticker too, on the pic two posts before where the car is on the trailer with the back.

And here are a few more impressions from the first trackday

Because my lip literally flew away on the trackday (it didn't hold up quite as well before) I opted for the Renault Sport Cup lip for C3RS Ph.1, the offset between the sill and the standard lip has always bothered me. I ordered it from RS Performance, it even came within 2 days. Assembled...

My car/Suspension was set up last week Then it went straight to the Bilster Berg and OpenPitlane Trackday on Sunday. First test passed successfully, only had the problem 3-4 times that a charge air hose blew off, but managed on site that it worked over the track day.

My car is ready!!

Go on: Uniball Wishbone Bearing + Rear Axle CAE-Shifter built-in

Clean and polished :thumb:

KW Competition 2A inside :thumb:

Small update, this week my Lambda controller from Innovatec came with a Bosch LSU 4.9 probe. So I was finally able to connect all sensors with my CanChecked MFD15 and tie and lay the wiring harness properly. If the values reach a min / max value set by me, they are displayed in blue (too low)...

Ah Yeah, i had a Problem with alternator that the Radiator Was put on. I had to fit the watercooler at an angle. You See the spacer

There is a lot of space when the Expansion Tank is moved to the left (Frontview). I share These days a pic :thumb:

Went a little further. Unfortunately, a lot of waiting time passed because I had to wait for various hoses. (Sometimes C3RS hoses were still used, which had to be exchanged for M2RS) Adapter plate for oil filter + oil cooler, oil pressure sensor and oil temperature sensor installed and wired...

A lot has happened.

Hi guys, By mistake i yesterday resetted my complete UCH from my Clio 3 with ddt4all now my keycards Do not work. Is it able to learn it again with ddt? Big thanks

Its Luisi Mirage Race. 350 mm. Bowl 75 mm

I've done some things the last days :-D

Today it went on. Remove unimportant cables, remove ventilation box and tar mats. + And I started to close the ventilation on the dashboard and then let it flock

Yesterday i began with the work :-D

First things i changed yesterday: Lightweight Flywheel + reinforced clutch from GT-Performance New thermostat, because it wasnt working steady. First pic attached.

No. 2854 / DB - delivered in Belgium, now in Germany :thumb: