Recent content by Flames83

Hi Yeah that’s what i meant, no all standard . It’s more then the flat spot had the car 4 year and this is new.it’s Really annoying me

Hi all Iv got a strange missfire between 1500 and 2000 rpm dose not do it all the time if I hold revs at 1500 rpm for 30 seconds it get lumpy ? Plugs done 4000 miles same as coil packs (aftermarket ones ) it’s had new tdc and mass air flow sensor with lamber last year not warning lights up ...

Hi mate Have you still got your alloys for sale? And what would you want for them? Cheers James

Better pic

After replacing map sensor all 4 coil packs and still not getting anywhere . Chris has a twingo with 197 engine in it with similar problem and that was first lamber sensor so replace it and I found this

A massive thanks to Chris at beanieSport helping to figure out the problem with the Clio. What a nice and very knowledgeable and professional person . Would highly recommended BeanieSport Milton Keynes

Still no joy , just really bad when hot. Could this be lamber sensor? When they change this at mot I had problems from then and they said it was cam sensor . Has any one had problems with after market lamber sensor??

Yes was from Ren parts. Think I might found it . Replaced map sensor to day and is loads better but still think there is a hesitation at 2000 rev .

Hi all Need some help car has a really bad hesitation when up to temp. To the point it struggles to pull away. Height up the Rev range it’s better.when you rev it it’s fine . Iv check plugs ( not that old) No Fault codes when read. Had to change lamber sensor and cam sensor two weeks ago...

All sorted new cam sensor eurocarpart £20 . Running spot on again

Ha prob the highest. Was running spot on .

hi all The car has fail the last few MOT on emissions so I have change CAT and sent it in today. Rite car Fail see pic . Was told lamber senior which I told them to change . After changing it they still struggle to pass it but they did in the end. This is where I need your HELP. Took the car...

Good work there, unfortunately it’s miss completely

I didn’t go for it in the end will just have to wait till I find the correct liner . Cheers