Recent content by Dan hickson

Hi I have brought a Sablet boss and steering wheel and upon fitting the boss it only seem to go on the splines about 5mm which in my eyes its not on far enough. Any advise welcome

Hi is anyone selling a foot plate rest for once carpets been removed

Does any recognise this exhaust system?

Will have to do something as the sensor which is there is pressing into the pipe. Is that the knock sensor located above the oil cooler ?

no just standard just noticed the pipes look squashed slightly

Hi can anyone post some pictures of there oil cooler with positioning of the two pipes attached to it.. the pipes on mine look over bent limiting the flow. Not sure the position of them as would think it only goes one way with length of pipe available..

Strut brace would be a good idea

Do people use the turret strengthening plates when upgrading to coil overs

what’s the best looking black alloy wheel that suits the 197 ? been looking and still find hard to beat the standard spoked wheel or speed line

Can anyone advise please, Had loss of high rev power as if the VVT is not operating as it should. I have checked and tested the vvt solenoid and cleaned. Car drove as it should stopped for 10 minutes and then loss of power again. Now looking at the cam position sensor, does anyone no what...

Hi has anyone had or know of the vvt solenoid sticking in advance or retard before ?? Thanks

Let me know the out come on handling once you get back on road

I have recently installed Coilovers and poly bushes on 197 and would like the geometry setting up and corner weights so handling hasn't be compromised. Can anyone advise preferably in the East Midlands region Thanks

item 10 is rear axle I need bushes for bottom of dampers on rears but cannot find anything. Been told it should of come with Gaz gold Coilover kit

Hi I have a 197 F1 cup and disappointed in the low rev range pick up seems to be fairly flat.... is this normal ???