Brunoandrade98's latest activity
-
The DS2500s were okay, they were even used for a few track days. I don’t really have anything to compare them to as we just put better... -
Brunoandrade98 replied to the thread OEM vs YellowStuff pads.Thanks for your input, really appreciated! See...I can absolutely bottom out my brake pedal without too much force and I'm just a...
-
If you have had not changed your brake fluid for a year you could flush out the old brake fluid and replace it with something like Motul...
-
Hi All, My front pads are due and the rear pads are following closely behind. I fitted them about the same time 3 years ago and...
-
Brunoandrade98 replied to the thread Engine rebuild due - DIY?.It’s low on power, more than likely as a result of the compression loss. There’s also a bad engine shudder, which I suspect is related...
-
Why are you rebuilding if you’ve consistent dry figures?
-
So, my engine will soon be due a rebuild due to low compression. Dry VS wet compression test indicate piston ring wear and compression...
-
Hi All, My Clio 197 has developed an intermittent airbag fault light. I already fiddled with both front seat plugs, which you can see...
-
-
Brunoandrade98 replied to the thread Low compression?.Thanks for the input! Read my reply above this one for an update. Honestly, the car never felt that punchy, so I suspect it's...
-
It’s been ages since I tested one, but I’m pretty certain of the 2 I’ve done, both were ‘low’ like yours. Both made good power on the...
-
Brunoandrade98 replied to the thread Low compression?.So, just re-ran the test and the results are in (not good). With the throttle wide open, I ran a dry test first and all 4 cylinders...
-
Brunoandrade98 replied to the thread Low compression?.I actually haven't, no! Didn't even think about that, to be honest. Since it's an electronic throttle body, does it really open while...
-
did you spin it over the same time for all cylinders and make sure the throttle was fully open?
-
Hi all, After trying to get to the bottom of a lumpy idle, I decided to buy a tester and do a compression test on all cylinders. The...
