Catback Exhaust System opinions?

What would be your pick?

  • Milltek

    Votes: 2 8.3%
  • Toyosport

    Votes: 1 4.2%
  • Cobra

    Votes: 2 8.3%
  • KTR

    Votes: 3 12.5%
  • Other

    Votes: 10 41.7%
  • Scorpion non res

    Votes: 1 4.2%
  • Scorpion res

    Votes: 5 20.8%

  • Total voters
    24
Not sure what mine is but sounds just like Cossers, lovely sound but does get a little frustrating at low speed (especially if you are in the back seats LOL), crackles, pops, bangs etc and at 70 mph would nearly drive you insane........
:blackdiamond:
Literally drove past you today again on the same road and had the window down.

You were going slow but it left a lovely rumble behind it, was actually going to message you and see if you knew what system you have.

Think I've decided to go for a scorpion but now I don't know if I need resonated or not.

Will resonated be too quiet and a waste of money?
Will non-resonated be too loud?

Scared of getting the wrong one and regretting it either way [emoji22]

Worst thing is I'm ready to buy now and busting too! [emoji23]

Sent from my ONEPLUS A5010 using Tapatalk
 
Lol get a res and if it’s too quiet let me know as I’ve got a scorpion non-res centre section gathering dust
 
  • Like
Reactions: Roshi69
If your around tomorrow give me a shout and l can let you see and hear it up close. I'll be in shorts from around 1030 to 3 pm. Have you been to Street Racer he is currently working (l hope) on putting quad pipes and back box on my Z4...Nothing but good reports about him, give him a visit (Andrew) and he will talk it through with you he's a decent bloke pm me and l will give you a call?
 
  • Like
Reactions: Roshi69
Thanks for taking the time today, was good to get a chat with you.

I should be good for Dobbies at 1. I will post in the other thread about it and hopefully see a few of the NI one's there [emoji4]

Sent from my ONEPLUS A5010 using Tapatalk
 
  • Like
Reactions: R11HOY
I think I have an exhaust system on but I don’t know what a standard 200 cup sounds like so I may be wrong lol. Hopefully see yas on Sunday


Sent from my iPhone using Tapatalk
 
  • Like
Reactions: Roshi69 and Beany
I have an exhaust system then. Wouldn’t know what. It’s not an Akra I know that much


Sent from my iPhone using Tapatalk
If ya get chance poke your head underneath the rear of the car.. usually there’s a brand stamp on the silencers (there is with the scorpion system) however diffuser may cover it up
 
  • Like
Reactions: GarethM3 and Pav
If ya get chance poke your head underneath the rear of the car.. usually there’s a brand stamp on the silencers (there is with the scorpion system) however diffuser may cover it up

Definately diffuser is in the way. I’ll have a nosey when it’s dry [emoji1303]


Sent from my iPhone using Tapatalk
 
  • Like
Reactions: Beany
Thread settled for me folks......

Got the Scorpion Non-Resonated cat back installed today and am over the moon with it so far.

Makes a really deep grunting noise and isn't overly loud. Plenty of pops and bangs and is exactly what I was after. So glad with my decision, thanks everyone for the assistance [emoji16]

Hadn't looked at the exhaust system before and didn't realise you had to actually cut the standard pipe 70mm from the lambda sensor. Just a note in case anyone gets one thinking it's a straight swap like it did [emoji23]6353acb4d9fea9bb2824a70633284a5d.jpgb8fc209863260089aaeb89ff7b9f614c.jpgfb7c1e3580054350d1afdafaac6c7bb6.jpg1f1b2aadcd2b1c090dbafa11ab71f63c.jpg64184517229cec37586f1a35cb19e462.jpga65c36a71e92e4aa02277c125510d3c4.jpg8b0b3f6f7edb7a3efb288051375a826a.jpgb65aafc522d922b8440588d02566b97d.jpg

Sent from my ONEPLUS A5010 using Tapatalk
 
Thread settled for me folks......

Got the Scorpion Non-Resonated cat back installed today and am over the moon with it so far.

Makes a really deep grunting noise and isn't overly loud. Plenty of pops and bangs and is exactly what I was after. So glad with my decision, thanks everyone for the assistance [emoji16]

Hadn't looked at the exhaust system before and didn't realise you had to actually cut the standard pipe 70mm from the lambda sensor. Just a note in case anyone gets one thinking it's a straight swap like it did [emoji23]6353acb4d9fea9bb2824a70633284a5d.jpgb8fc209863260089aaeb89ff7b9f614c.jpgfb7c1e3580054350d1afdafaac6c7bb6.jpg1f1b2aadcd2b1c090dbafa11ab71f63c.jpg64184517229cec37586f1a35cb19e462.jpga65c36a71e92e4aa02277c125510d3c4.jpg8b0b3f6f7edb7a3efb288051375a826a.jpgb65aafc522d922b8440588d02566b97d.jpg

Sent from my ONEPLUS A5010 using Tapatalk

Lol yeah there’s a guide indicating so much needs chopping off... or get a decat pipe problem solved :wink:
 
  • Like
Reactions: Roshi69
With scorpion main catalytic is removed? How about mot check with emissions.
What do you think about power cure with new exhaust, any flat spot?
 
Mine has a non res, decat and full induction kit and passed the mot with no probs last December:smile:
Ditto.. if there’s one cat still there it’ll pass an mot on emissions. Unsure on new mot rules coming into effect soon
 
It's been proven the pre-cat in the manifold is fine for keeping emissions under control at MOT time. The main focus will be on diesel particulate filters, so you should be fine :smile:
 
  • Like
Reactions: Beany
How much did you end up getting it for fella and where from? If you don't mind me asking cheers
Adi
Lol yeah there’s a guide indicating so much needs chopping off... or get a decat pipe problem solved :wink:

Sent from my Pixel using Tapatalk