Trackspec Clio 197

I've not tried it so this isn't from experience but I think it would just stop keyless entry working as well as keyless start. So the card would need to be in the slot each time. My battery died recently in the card and this was the result too.

Correct, well it was for me. Card in reader will still start the engine. You can however still the lock the doors, by locking the drivers from the inside and locking the car with the conventional key from the passenger side. Well that worked for me.


Sent from my iPhone using Tapatalk
 
  • Like
Reactions: trackspec197
That new block is seriously clean!
Will it be ready for Bedford on the 4th Nov?
Yeah has cleaned up well and just a little paint made a difference.

The 4th is the aim still. I have a few jobs to do on it besides the engine swap. Before it gets fitted I want to have the subframe shot blasted and powder coated too then all new bushes too. It makes sense to do it now.
 
  • Like
Reactions: Big Ben
Yeah has cleaned up well and just a little paint made a difference.

The 4th is the aim still. I have a few jobs to do on it besides the engine swap. Before it gets fitted I want to have the subframe shot blasted and powder coated too then all new bushes too. It makes sense to do it now.
I haven't forgotten them DS1.11 by the way. Funds are allocated to something else at the minute:wink:
 
  • Like
Reactions: trackspec197
Bit more progress today. Managed to take the motor out. A few issues like the hub nuts been overtightened by the guys who fitted the gearbox and a stuck driveshaft but otherwise all done.

IMG_3760.JPG

Just need to clean it all up now and fit the heat shielding etc which I will do tomorrow.

Also planning on sending the gearbox for a check over next week before fitting.
 
  • Like
Reactions: peter and Pav